Manufactured In The USA

Installation of PPF

How to Install Paint Protection Film (PPF)

1. Preparing Your Slip and Tack Solutions

Before starting the installation, you’ll need two essential solutions:

  • Slip Solution (used for positioning the film)
  • Tack Solution (used for securing edges and high-tension areas)

Slip Solution Mixture:

  • 32 oz (1 quart) of distilled water
  • 3-5 mL (a few drops) of baby shampoo (e.g., Johnson’s Baby Shampoo)

👉 Purpose: The slip solution allows the PPF to slide easily on the surface, making adjustments before tacking it down.

Tack Solution Mixture:

  • 32 oz (1 quart) of distilled water
  • 1-2 oz of isopropyl alcohol (70% or 90%)

👉 Purpose: The tack solution helps the film adhere more aggressively to high-tension areas, ensuring a firm grip where needed.

2. Surface Preparation

  1. Wash and Decontaminate:
    • Use a pH-neutral soap and clay bar treatment to remove contaminants.
    • Dry the surface completely before application.
  2. Clean with Isopropyl Alcohol:
    • Wipe down the panel with a microfiber towel and isopropyl alcohol to remove any wax or oils.

3. PPF Installation Process

Step 1: Positioning the Film

  1. Spray the slip solution generously on both the paint surface and the adhesive side of the film.
  2. Carefully lay the PPF onto the panel, ensuring full coverage.
  3. Adjust the film until it aligns correctly with the body panel.

Step 2: Tack Down Anchor Points

  1. Use the tack solution on key anchor points where the film will be secured first (e.g., edges, emblem cutouts, or corners).
  2. Spray tack solution under the film in these areas, squeegee out the excess liquid, and press firmly.

Step 3: Stretching the Film (If Needed)

Some areas, such as curved hoods, bumpers, and fenders, may require stretching:

  1. Hold the PPF firmly and gently stretch it to fit the contours of the vehicle.
  2. Avoid overstretching, as it can distort the film’s structure.
  3. Once in place, use tack solution and a squeegee to secure stretched areas.

Step 4: Squeegeeing and Removing Air Bubbles

  1. Start from the center and work outward to remove trapped liquid and air bubbles.
  2. Use firm, overlapping strokes with a soft squeegee.
  3. If bubbles persist, carefully lift the film, apply more slip solution, and reposition it.

Step 5: Final Edge Sealing

  1. Use tack solution along edges and high-stress areas.
  2. Press the film down with a microfiber towel or edge-sealing tool.
  3. Allow 24-48 hours for the film to fully cure.

4. Post-Installation Tips

  • Avoid washing the car for at least 48 hours after installation.
  • Check for lifting edges within the first 24 hours and press them down if necessary.
  • Use PPF-safe products for maintenance to prevent film damage.